Cat House Plans: Easy baby DIY project for a changing table pad for the Ikea Sniglar

When we were preparing baby Nolan's room, I really wanted to go without a changing table because I thought it would take up way too much space. Plus, I'm a minimalist, so I really wanted to make it happen without a changing table (and use the floor or a sofa instead).

This minimal notion lasted for about a week after Bebo was born. 100 million diapers later (just an estimate), I went to IKEA to purchase a changing table. The SNIGLAR is great because it's only $35 and it is very functional and uncomplicated!

So I bought the SNIGLAR, but we didn't buy the IKEA changing table pads because I already had one at home that I received as a baby shower present.

However, when I got home, the Summer changing pad I received was too large. I was pretty bummed. However, Google saves the day because I came across this DIY post. Turns out it's super simple to cut down the Summer changing pad and re-sew the sides!

I'm not an expert sewer by any means; I purchased the supplies needed and completed the project within an hour or two. If you're a good sewer, you can do this a lot faster and without as many mistakes as I made!

Supplies and Materials Needed

Summer Four-Sided ChangingPad - perfect for a IKEA DIY hack - Easy baby DIY project for a changing table pad for the IKEA SNIGLAR

DIY Step 1: Measure your changing table

The SNIGLAR table is wide enough but isn't long enough to house the whole changing pad. Measure the overall length of the SNIGLAR table (about 27 inches).

Measure - Easy baby DIY project for a changing table pad for the IKEA SNIGLAR

DIY Step 2: Cut along the stitches on one end

Now that you know the overall length, it's time to open up some of the seams on the changing pad. Use scissors to cut the end off, making sure to be cutting along the end's half of the seam in order to preserve the most amount of outer-layer fabric for sewing back together later.

Cut the end off - Easy baby DIY project for a changing table pad for the IKEA SNIGLAR

DIY Step 3: Cut the changing pad down to size

Now that you have the ends exposed, cut your changing pad down to size.

You'll be cutting through a layer of cardboard as well as the foam.

Cut the cardboard and foam to size - Easy baby DIY project for a changing table pad for the IKEA SNIGLAR

See if the changing table pad will fit your SNIGLAR changing table. If it will, go ahead to the next step. If you goofed like I did (I didn't cut enough away), you can trim it down again until it fits in your SNIGLAR.

Trim additional foam if you didn't cut the pad short enough

Fold the bottom fabric back around the cardboard

Fold the top fabric and clip it down so you can sew and leave a nice edge. I did this in the Funky Side Crow method but you can repair the cuts on the changing pad in any way you wish.

DIY Step 5: Fix mistakes (optional if you messed up like I did)

When I did this, I accidentally cut away too much of the top fabric, so when I sewed my changing table pad, I ended up with a couple of bald spots.

In order to fix this, I simply put scrap fabric underneath the bald spot, sewed it into the edge, and then hot glued the extra flaps down in the center.